Hi Dmitry.
I am running Neutron MP on a Kindle Fire (version 5) with an AudioQuest DragonFly DAC and JitterBug.
I had been getting various, intermittent crackling noises before, that went away when I upgraded to 1.88.2.
Now they are back in 1.88.3 (not as bad as before, but still there)
Do you know of any reason that these would have returned? I like 1.88.3 a lot better than 1.88.2, because the 96K setting works correctly now, but I would also like to be rid of the crackling noise.
(There also seem to be some stability problems that cause Neutron MP to periodically stop playing, but I assume you would need the Kindle to debug that.)
Thanks again for a great product!
Otaku
Crackling
Re: Crackling
Same here!!!!
I noticed 1.8x series have Sq problems, more or less.
Clicks, crackling, ...etc happen when up sampling process.
From myself experience I have something little:
1. Turn off 64 bit
2. Turn to std audio sampling (NOT precise mode,audiophile)
3. Change HW delay to smaller and SWEET delay to bigger
Running 352khz with most no problems (still have few) and choose a lower like 176 is more reduce phenomenon
RG
I noticed 1.8x series have Sq problems, more or less.
Clicks, crackling, ...etc happen when up sampling process.
From myself experience I have something little:
1. Turn off 64 bit
2. Turn to std audio sampling (NOT precise mode,audiophile)
3. Change HW delay to smaller and SWEET delay to bigger
Running 352khz with most no problems (still have few) and choose a lower like 176 is more reduce phenomenon
RG
Re: Crackling
Thanks. I tried your suggestions, and I think they helped a little, but it is still annoying.
Who is online
Users browsing this forum: No registered users and 25 guests